"I decided to build a sled for ice fishing and thought emt conduit would be a great choice to build the frame; light-weight and strong. I have experience bending conduit so a difficult task like sled design should be easy enough. However, I soon discovered emt connectors, like a t-connector, really don't exist. I stumbled upon Maker Pipe while searching and it was exactly what I was looking for. I ordered the mixed structural kit as I needed 12 t-connectors and 4 45 degree connectors for my project.
The connectors are heavy duty and easy to work with, simply wrap around the pipe, slip screw through and hand tighten to to the nut. I assembled most of the frame, made sure I was square, then went back and tightened each connector with the provided hex key. The connectors draw super tight and prevent any slip around the pipe. I had used heat shrink around my entire pipe so I didn't need the heat wrap shims they provide on the connectors, and they also give you a small back of extra shims.
Entire project used 4 1/2 lengths of conduit, 1 35' roll of heat shrink wrap, 12 Maker Pipe t-connectors, 4 Maker Pipe 45 degree connectors, 5 pieces 3/4 pipe insulation and 3 rolls of hockey tape. Had an old pair of skis in back shed so whole project ended up costing just over $100.
Works great! Entire sled weighs 30 lbs and hauls over 350 lbs of gear. I normally haul about 100 lbs of gear but we let the senior fellas stand on the ski's and we push them out too. The connectors have never moved or shifted, they are rock solid.
I will certainly being using Maker Pipe again...already have many requests for a sled like mine.
Project turned out great!. I wrapped much of my pipe with foam and tape to prevent scuffing from the equipment I haul." - Craig