Is it feasible to use a T Connector as a coupler for two separate through pipe(s)? In other words, I desire to have a single 1" EMT conduit pipe up through the bottom of the T Connector and two separate 1" pipes joined in the top of the T Connector as if they were a single through pipe. These two pipes have special bends (away from the desired T Connection) and I'd prefer not to use a separate coupler to join them since that would need to reside right where I want the T Connector to join them to the single pipe going down. Maybe I could sleeve the two through pipe sections and the T Connector would then hold them securely. If that's a better approach, does Maker Pipe have a suggestion or product for sleeve material?